TABLE 1. Copper-base Alloys: Finishing and Coating Issues 15-100 ft/min. as determined by recrystallization, stabilization and aging). Cleaning Acid cleaning, 20-60 ft/min. Surface quality (inorganic tarnish). Solderability/toolwear are important properties. L L H H Cold rolling Gauge and width are standard but critical issues. H H 0.1" -> 0.005", 200-1500 ft/min. Surface quality (mechanical defects/cosmetics). Absolute property measurements are not seen as essential. A measure of product uniformity that is tightly correlated with a property or category of properties would permit the manufacture of product that could be certified according to customer needs off line (static). Long Range Research - North American Steel's Competitive Sensor, Process Models, and Control Needs in the Aluminum 10:45 am COFFEE 11:15 am 12:00 pm 12:45 pm 1:00 pm Industry - R. Bonewitz (Alcoa) Introduction of Session Chairmen/Workshop Instructions- L. H. Schwartz (NIST) LUNCH West Square Cafeteria 3:40 pm Sensor Requirements for the AISI Direct Steelmaking Sensor Needs in Copper Smelting - J. Fay (ASARCO, Inc.) COFFEE - Employees Lounge Sensors - A. McLean (University of Toronto), Chairman - A. McLean (University of Toronto) Optical Diagnostics for In-Situ Measurements in Continuous Measurements of Molten Metal Composition |