Investigation of Performance Characteristics for Sanitary Plumbing FixturesU.S. National Bureau of Standards, 1970 - 68 pages |
From inside the book
Results 1-5 of 31
Page
... Determination of Eccentricity of Floor Loads Applied to a Bearing Wall . 15 cents BSS15 . Interrelations Between Cement and Concrete Properties : Part 4 , Shrinkage of Hardened Port- land Cement Pastes . 75 cents BSS16 . Techniques for ...
... Determination of Eccentricity of Floor Loads Applied to a Bearing Wall . 15 cents BSS15 . Interrelations Between Cement and Concrete Properties : Part 4 , Shrinkage of Hardened Port- land Cement Pastes . 75 cents BSS16 . Techniques for ...
Page 6
... Determine the sump center lines by using the average length and width of the sump . Place the three micrometer dial ... determined 10 min after remov- al of the applied load is not to exceed 0.008 in . ( 2 ) Test Data The relationship ...
... Determine the sump center lines by using the average length and width of the sump . Place the three micrometer dial ... determined 10 min after remov- al of the applied load is not to exceed 0.008 in . ( 2 ) Test Data The relationship ...
Page 8
... determine if a bathtub will withstand a 300 - lb . load applied at the center of the front rim without damage . The service load simulated is that of a person sitting or standing on the bathtub rim . b . Recommended Test Method ( 1 ) ...
... determine if a bathtub will withstand a 300 - lb . load applied at the center of the front rim without damage . The service load simulated is that of a person sitting or standing on the bathtub rim . b . Recommended Test Method ( 1 ) ...
Page 9
... determined by per- formance requirements for the static load test ( sec . 2.2 ) . In addition , lateral movement and ... determine if the bathtub will withstand , without visible damage , an impact load simulating a person falling or ...
... determined by per- formance requirements for the static load test ( sec . 2.2 ) . In addition , lateral movement and ... determine if the bathtub will withstand , without visible damage , an impact load simulating a person falling or ...
Page 10
... determined as in paragraph 2.2 b ( 3 ) , and marked . ( 3 ) Test Procedure Maintain the temperature of the testing labora- tory and bathtub at 75 ± 5 ° F . Drop the bag suc- cessively from heights of 5 , 10 , and 15 in , measured ...
... determined as in paragraph 2.2 b ( 3 ) , and marked . ( 3 ) Test Procedure Maintain the temperature of the testing labora- tory and bathtub at 75 ± 5 ° F . Drop the bag suc- cessively from heights of 5 , 10 , and 15 in , measured ...
Common terms and phrases
abraded abrasion ammonium hydroxide apparatus ASTM designation blisters Bon Ami bottom brush Brush Brush Brush Bureau of Standards cast-iron center deflection cleanability cleaning color Comments on Performance Commercial Standard cracking cycles damage depth detergent dial gage diam Discussion of Existing drain enameled evaluate exposure fixture materials flat specimens FRPE bathtubs FRPE fixtures FRPE specimens gel-coat household chemicals inspection installed iron laboratory manufacturers Mercurochrome National Bureau observed percent Performance Level Performance Requirements plastic polyester porcelain proposed revision Purpose and Scope Rationale for Suggested Rationale for Test Recommended Test Method removal resistance rating sanitary plumbing fixtures sanitary ware Scope The purpose scouring powder scratch scratch test scrub section 2.8 simulate slip resistance slurry soap Sodium soilability soiling agent Spec stain rating Suggested Format sump surface TEFLON temperature test area Test Development test procedure Test Results Tester thermal shock tion vitreous china watch glass weight
Popular passages
Page 4 - In no case does such identification imply recommendation or endorsement by the National Bureau of Standards , nor does it imply that the...
Page 1 - This report gives findings and recommendations developed during an investigation of performance characteristics for sanitary plumbing fixtures, conducted at the request of the Building Research Advisory Board of the National Academy of Sciences-National Research Council. The...